An Improved Photovoltaic Module Array Global Maximum Power Tracker Combining a Genetic Algorithm and Ant Colony Optimization

In this paper, a hybrid optimization controller that combines a genetic algorithm (GA) and ant colony optimization (ACO) called GA-ACO algorithm is proposed. It is applied to a photovoltaic module array (PVMA) to carry out maximum power point tracking (MPPT). This way, under the condition that the PVMA is partially shaded and that multiple peaks are produced in the power-voltage (P-V) characteristic curve, the system can still operate at the global maximum power point (GMPP). This solves the problem seen in general traditional MPPT controllers where the PVMA works at the local maximum power point (LMPP). The improved MPPT controller that combines GA and ACO uses the slope of the P-V characteristic curve at the PVMA work point to dynamically adjust the iteration parameters of ACO. The simulation results prove that the improved GA-ACO MPPT controller is able to quickly track GMPP when the output P-V characteristic curve of PVMA shows the phenomenon of multiple peaks. Comparing the time required for tracking to MPP with different MPPT approaches for the PVMA under five different shading levels, it was observed that the improved GA-ACO algorithm requires 19.5~35.9% (average 29.2%) fewer iterations to complete tracking than the mentioned GA-ACO algorithm. Compared with the ACO algorithm, it requires 74.9~79.7% (average 78.2%) fewer iterations, and 75.0~92.5% (average 81.0%) fewer than the conventional P&O method. Therefore, it is proved that by selecting properly adjusted values of the Pheromone evaporation rate and the Gaussian standard deviation of the proposed GA-ACO algorithm based on the slope scope of the P-V characteristic curves, a better response performance of MPPT is obtained.