Removal of dyes by poly(p‐phenylene terephthamide)/polyvinylidene fluoride hollow fiber in‐situ blend membranes

ABSTRACT In order to obtain the compatible poly( p ‐phenylene terephthalamide) (PPTA)/polyvinylidene fluoride (PVDF) blend membranes, the casting solution was synthesized via the in situ polycondensation process and flat sheet blend membranes were successfully prepared through the immersion precipitation phase inversion method in our previous study. In this study, the polycondensation solution was directly used as the spinning dope to fabricate PPTA/PVDF hollow fiber in‐situ blend membrane by the dry‐wet spinning technique. Hollow fiber membranes were employed to remove the dyes including Congo red (CR) and methylene blue (MB) from the dyeing liquor. Effects of operation conditions on dye rejection and membrane water flux were investigated. With the increase of operation pressure, feed concentration and feed temperature, dye rejection rates gradually decreased, but the rejection value of CR and MB still remained above 99.5%. On the contrary, the permeation water flux basically increased. During the continuous dye filtration of 300 min, hollow fiber membrane can maintain high dye rejection rates and stable water flux. The combination method of physical backwashing and chemical cleaning can effectively alleviate membrane fouling and recover membrane water flux. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020 , 137 , 48569.