Laser surface remelting of powder metallurgy high-speed steel

The effect of laser processing on the structure, microstructure and hardness of high-speed steel produced by powder metallurgy was investigated. The samples were surfaces remelted with impulse CO2 laser radiation under different operation conditions. In the remelted layer, the presence of full remelting, partial remelting and heat affected zones was detected. As a result of concentrated laser beam treatment, microstructures characteristic of the rapid crystallization process were observed. The microstructure in the full remelting zone was characterized by a fine microdendritic structure with the average distance between the secondary axes of dendrites below 1 µm and the dissolution of primary carbides. Retained austenite was found in the remelted samples, the amounts of which depended on the treatment parameters and grew with an increase in the speed of the laser beam movement. There was no unequivocal effect of the distance of the irradiated surface from the focus of the beam focusing system on the content of retained austenite. Due to the presence of retained austenite in the remelted part, the hardness decreased by about 23% compared to the hardness of the material before the treatment. On the other hand, laser processing leads to strong refinement of the microstructure and eliminates the residual porosity of powder steels, which can increase the toughness and cutting performance of steel. The research also showed the possibility of shaping the geometry of the remelting zone by the appropriate selection of machining parameters