Strengthening phase and mechanical property analysis of artificially aged Al7075 – Ni coated Al2024 composites

Abstract This technical paper demonstrates the possibilities of nickel (Ni) coated Al2024 powder reinforcement in an Al7075 matrix using the liquid stir casting technique. Additionally, the paper focuses on achieving stable properties by implementing artificial aging heat treatment. To apply the Ni coating, the electroless nickel plating technique was utilized, and a minimum coating thickness of 8 μ m was determined to effectively prevent the dissolution of Al2024 powder reinforcements within the Al7075 matrix. Stir casting facilitated the uniform dispersion of the coated Al2024 powder up to a weight percentage of 7%. Subsequently, the Al7075 alloy and composites underwent artificial aging through solution heat treatment (SHT) at 450 °C for 4 h, followed by water quenching and aging at temperatures of 120, 150, and 180 °C. Aging at 120 °C was found to yield superior results compared to aging at 150 and 180 °C, thus identified as the optimum aging temperature. When the Ni coating thickness was increased beyond the optimal 8 μ m, the resulting enhancements in hardness for both as-cast and peak-aged specimens, as well as the tensile strength, were not significant. The improvements observed were only marginal, ranging between 2 to 3%. Fracture surface analysis revealed that the predominant fracture mode in the Al7075 alloy was ductile, characterized by dimple rupture. In the as-cast Al7075-(7%, 8 μ m) Al2024 composite, a mixed fracture mode comprising both brittle and ductile characteristics was observed. In the peak-aged (120 °C) Al7075-(7%, 8 μ m)Al2024 composite, the overall fracture mode exhibited a dominant brittle nature. Analytical techniques including XRD, TEM, and EDS confirmed the presence of Mg 2 Si, MgZn 2 , CuAl 2 , and CuAl 2 Mg phases in the peak-aged (120 °C) Al7075-(7%, 8 μ m) Al2024 composite. These phases contributed to the enhancement of the properties of both the Al7075 alloy and its composites. The developed composites can be used in automobile parts and aerospace applications.