Investigations on the effects of obstacles on the surfaces of blades of the centrifugal pump to suppress cavitation development

This paper proposes a new method that obstacles are attached to both the suction and pressure surfaces of the blades to suppress cavitation development. A centrifugal pump with a specific speed of 32 is selected as the physical model to perform the external characteristic and cavitation performance experiments. SST [Formula: see text] turbulence model and Zwart cavitation model were employed to simulate the unsteady cavitation flow in the pump. The results indicate that the numerical simulation results are in good agreement with the experimental counterparts. After the obstacles are arranged, the maximum head decrease is only 1.37%, and the relative maximum drop of efficiency is 1.12%. Obstacles have minimal impacts on the variations of head and efficiency under all flow rate conditions. The distribution of vapor volume in the centrifugal pump is significantly reduced after obstacles are arranged and the maximum fraction reduction is 53.6%. The amplitude of blade passing frequency decreases significantly. While obstacles decrease the intensity of turbulent kinetic energy near the wall in the impeller passages to effectively reduce the distribution of cavitation bubbles, and control the development of cavitation. After the obstacles are set, the strength of the vortex in the impeller passages is weakened significantly, the shedding of the vortex is suppressed, flow in the impeller becomes more stable.