材料科学
奥氏体
微观结构
回火
猝灭(荧光)
可塑性
马氏体
极限抗拉强度
冶金
板条
变形(气象学)
扫描电子显微镜
复合材料
量子力学
荧光
物理
作者
Yan Peng,Caiyi Liu,Ningning Wang
出处
期刊:Chinese journal of mechanical engineering
[Elsevier]
日期:2021-11-27
卷期号:34 (1)
被引量:2
标识
DOI:10.1186/s10033-021-00634-8
摘要
Abstract The current research of the Q-P and Q-P-T process has been focused on controlling the heating temperature and holding time, or adding alloy elements into the steel to induce precipitation strengthening and improve the strength and plasticity of the steel. In this article, based on a quenching-partitioning-tempering (Q-P-T) process combined with a hot deformation technology, a deforming-quenching-partitioning-tempering (D-Q-P-T) process was applied to medium carbon steel. The effect of the heat treatment parameters on the microstructure and mechanical properties of experimental steel under deformation was studied. Through use of a scanning electron microscope (SEM), transmission electron microscopy (TEM) and tensile tests, the optimal heat treatment conditions for realizing high strength and plasticity that meet the safety requirements were obtained. The mechanism for the D-Q-P-T process to improve the strength and plasticity of experimental steel was discussed. A multiphase composite structure of lath martensite and retained austenite was obtained. Compared with the Q-P-T process, use of the D-Q-P-T process can increase the strength of steel by 57.77 MPa and the elongation by 5%. This study proposes a method to improve the strength and plasticity of steel.
科研通智能强力驱动
Strongly Powered by AbleSci AI