Characteristics of felodipine-located poly(ε-caprolactone) microspheres

AbstractFelodipine-loaded poly (ε-caprolactone) (PCL) microspheres were prepared by two methods, the conventional emulsion solvent evapouration method and the quenching method. The aim of this work was to investigate the effects of process parameters such as emulsion type, drug loading, molecular-weight of the polymer, types of emulsion stabilizer and dispersed phase solvents, as well as preparation methods. The results show that, when conventional emulsion solvent evapouration method was used, the o/w-method produced smaller mean size and higher encapsulation efficiency compared with the o/o-method. The encapsulation efficiencies increased with an increase in the molecular weight and a decrease in crystallinity of PCL. The size of microspheres varied with the type of emulsion stabilizer used, smaller microspheres with PVA and narrow size distribution with Pol 237. The water solubility of the dispersed phase solvent was one of the critical factors in controlling the encapsulation efficiency and microsphere mean size. When water-soluble solvents such as acetonitrile and ethyl formate were used, the encapsulation efficiencies decreased due to higher evapouration rate. When quenching methods were used, in contrast to the conventional emulsion solvent evapouration method, very narrowly size-distributed but bigger microspheres were obtained.Keywords: : Felodipinepoly(ε-caprolactone)conventional emulsion solvent evapouration methodquenching methodmicrosphere