砂纸
材料科学
润湿
微观结构
涂层
复合材料
接触角
六方晶系
往复运动
铝
超疏水涂料
融合
棱锥(几何)
磨损(机械)
磨料
莲花效应
热液循环
冶金
纳米技术
光滑表面
摘要
Superhydrophobic aluminum surfaces are attractive for self-cleaning, anti-corrosion, and anti-icing applications, but those produced by femtosecond-laser texturing alone often exhibit inadequate contact angles and poor wear durability. Here, femtosecond-laser ablation was used to fabricate five hierarchical microstructures on pure aluminum—cross-grid, inverted triangular pyramid, inverted quadrangular pyramid, inverted hexagonal pyramid, and hemispherical dimple—and the influence of microstructure geometry and characteristic size on wettability was systematically examined. For the 400 μm arrays, the water contact angle (WCA) rose from about 85° for bare aluminum to 124°–134°, being highest for the inverted triangular and quadrangular pyramids, yet all values remained below the 150° superhydrophobic threshold. The deepest inverted hexagonal pyramid instead underwent capillary infiltration and collapsed into a wetted state, with the WCA dropping sharply to about 21°. Refining the inverted triangular and quadrangular pyramids to edge lengths of 100 and 200 μm raised the WCA to about 150°, yielding superhydrophobicity that remained stable for 30 days. The microstructures were then used as a load-bearing armor for a commercial superhydrophobic coating. Under reciprocating sandpaper abrasion, the flat control coating failed at the third cycle, whereas the armored coating retained superhydrophobicity for about 6 cycles and persisted near the threshold up to about 28 cycles—an order-of-magnitude gain in wear life—through synergistic load transfer and geometric shielding. This work offers a green, maskless, and durable route to wear-resistant superhydrophobic aluminum.
科研通智能强力驱动
Strongly Powered by AbleSci AI