材料科学
合金
微观结构
体积分数
制作
电阻率和电导率
冶金
相(物质)
复合材料
电导率
电气工程
医学
工程类
病理
物理化学
有机化学
化学
替代医学
作者
Satoshi Semboshi,Yuto Takito,Yasuyuki Kaneno,Shigeo Sato,Hiroshi Hyodo
标识
DOI:10.2320/matertrans.mt-d2023009
摘要
The advancement of electronic devices and their capabilities has driven the demand for specific material property combinations, such as mechanical strength and electrical conductivity, in materials pertinent to device fabrication. To this end, the microstructure and properties of Cu–4.2 at% Ti alloy sheets, produced through a multi-step process involving over-aging and severe cold rolling, were investigated. The microstructure of the over-aged alloy prior to cold rolling consisted of cellular components with laminated plates of terminal copper solid solution (Cuss) and β–Cu4Ti. When the over-aged alloy was severely cold rolled for a 99% reduction in thickness, a hierarchical double-phase microstructure was formed parallel to the cold-rolling direction, with Cuss bands and two-phase bands containing small β–Cu4Ti pieces stacked within Cuss phase. The strength of the over-aged alloy sheet increased steadily during increasing degrees of cold rolling, caused by a large volume fraction and fine dispersion of hard β–Cu4Ti pieces and high dislocation density in the Cuss matrix. The electrical conductivity decreased in the later stages of cold rolling; however, the conductivity was higher than that of the alloy sheet prepared by peak aging and cold rolling. Eventually, the balance between strength and electrical conductivity of this Cu–Ti alloy was significantly improved by over-aging and severe cold rolling compared to conventional peak-aging and cold rolling processes.
科研通智能强力驱动
Strongly Powered by AbleSci AI