材料科学
压痕硬度
纳米复合材料
扫描电子显微镜
腐蚀
涂层
冶金
原电池
复合材料
化学工程
微观结构
工程类
作者
Siavash Imanian Ghazanlou,Somayeh Ahmadiyeh,R. Yavari
标识
DOI:10.1080/02670844.2016.1275484
摘要
Ni–Co/SiO 2 nanocomposite coating was deposited on the steel substrate by pulse electrodeposition method. The coatings were characterised by X-ray diffraction, field emission scanning electron microscopy technique, energy-dispersive X-ray spectroscopy and X-ray map (dispersive elemental mapping) analysis. The influences of stirring rate, pH and SiO 2 concentration parameters on the mechanical properties and corrosion resistance were studied. The zeta potential of SiO 2 nanoparticles was decreased by mounting the pH and also adsorption of the surfactant SDS. Microhardness, friction coefficient, wear and anodic polarisation were determined through Buhler microhardness tester, pin-on-disc wear test and potentiostat galvanic device, respectively. By applying optimum electrodeposition condition (stirring rate 200 rev min −1 , pH 4.6 and SiO 2 concentration 20 gL −1 ) incorporation of SiO 2 particles into the nickel–cobalt matrix increases which results in the preparation of coatings with high microhardness and corrosion resistance, low friction coefficient and wear mass loss.
科研通智能强力驱动
Strongly Powered by AbleSci AI