电润湿
材料科学
电压
光电子学
低压
纳米技术
电气工程
工程类
电介质
作者
Marcel Mibus,Xiaoyu Hu,Carl R. Knospe,Michael L. Reed,Giovanni Zangari
标识
DOI:10.1021/acsami.6b02791
摘要
Low-voltage electrowetting devices allow significant contact angle changes below a 50 V bias; however, operation under prolonged cycling and failure modes have not yet been sufficiently elucidated. In this work, the failure modes and performance degradation of Cytop (23-210 nm)/aluminum oxide (15-44 nm) bilayers have been investigated. Contact angle and leakage current were measured during stepped voltage measurements up to failure, showing three electrowetting response regimes: ideal Young-Lippmann behavior, contact angle saturation, and dielectric breakdown. The onset of ionic conduction in aluminum oxide and the resulting breakdown control when the layer would ultimately fail, but the thickness of the Cytop layer determined the achievable contact angle versus voltage characteristics. Cyclic electrowetting measurements studied the repeatability of contact angle change using an applied voltage above or below the voltage drop needed for polymer breakdown (VT). Results show repeatable electrowetting below VT and a rapidly diminishing contact angle response above VT. The leakage current and injected charge cannot be used to comprehensively assess the stability of the system during operation. The contact potential difference measured with a Kelvin probe provides an alternative means of assessing the extent of the damage.
科研通智能强力驱动
Strongly Powered by AbleSci AI