电解
离子交换
化学
无机化学
材料科学
化学工程
电解水
电催化剂
制氢
膜
催化作用
电极
氢
电化学
离子
析氧
水溶液
密度泛函理论
燃料电池
分解水
金属
作者
Mohsin Muhyuddin,Mirza Afnan Baig,Roberto Nisticò,Silvia Mostoni,Massimiliano D’Arienzo,Chiara Ferrara,Daniele Perilli,Jacopo Orsilli,Francesco d’Acapito,Ilaria Perissi,Enrico Berretti,Irfan Nadeem,Mitjan Kalin,Francesco Paparoni,Javad Rezvani,Rosanna Viscardi,Carmelo Lo Vecchio,Vincenzo Baglio,Irene Gatto,Plamen B. Atanassov
标识
DOI:10.1016/j.apcatb.2026.127730
摘要
s NiMo/C electrocatalyst (EC) can be a promising alternative to scarce and overpriced platinum group metals (PGMs) for the hydrogen evolution reaction (HER) in anion exchange membrane water electrolyzers (AEMWEs). However, resolving the optimal Ni-to-Mo ratio and understanding how the carbon support helps develop a suitable electrocatalytic architecture remain unclear. Therefore, two EC series with varying Ni-to-Mo ratios, supported over two different carbon substrates, i.e., Vulcan and Ketjenblack (KJB), were developed and thoroughly investigated. Structural characterizations via X-ray diffraction and X-ray absorption spectroscopy (XAS) highlighted that initially the Mo tended to substitute within the host nickel’s FCC lattice; however, increasing the Mo content led to the enhanced formation of bulk oxide phases, whereas different morphological makeovers were observed for both Vulcan- and KJB-based samples through the scanning transmission electron microscope. X-ray photoelectron spectroscopy indicated the highest Ni 2+ /Ni 0 ratio in Ni70Mo30/KJB; however, in both sample series, further increasing the Mo content led to a progressive enrichment of surface MoO₃, causing decay of HER performance. In the same samples, operando XAS specified beneficial Mo dissolution-redeposition while maintaining the Ni sites, primarily in a metallic state during HER, with limited and reversible hydroxide formation predominantly in the electrochemically active α-Ni(OH) 2 in the HER regime. The highest half-cell HER activity was achieved at a Ni: Mo ratio of 70:30, particularly with Ni70Mo30/KJB requiring an overpotential of only 119.6 mV. Eventually, when tested in AEMWE operating at 80 ºC with a NiFe 2 O 4 anode, it realized a current density of 3.82 A cm -2 at 2.2 V along with excellent operational durability.
科研通智能强力驱动
Strongly Powered by AbleSci AI