Homogenization spin coating strategy for synthesizing IM-BTO photocatalytic membrane aims to tetracycline selectively degradation

Photocatalytic membrane technology is a promising technology for advanced water treatment. However, as a simple, fast, and stable spin coating method for photocatalytic membrane preparation, the spin coating solution often used in spin coating can cause the pore plugging on the membrane surface and encapsulates photocatalysts, which seriously affects the flux of the membrane and the exposure of the photocatalytic active site. Here, this work adopted a homogenization spin coating strategy, using polyvinylidene difluoride (PVDF) solution as the spin coating solution to prepare the highly exposed imprinted bismuth titanate porous photocatalytic membrane (IM-BTOM). Due to the same composition of PVDF solution as the PVDF substrate membrane, IM-BTOM basically retained the good porous structure of the membrane. The homogenization spin coating strategy not only endowed IM-BTOM with high flux (4545.45 L m-2h−1 bar−1), but also prevented the encapsulation of IM-BTO powder materials, fully exposing the photocatalytic active sites, thereby obtaining better photocatalytic ability and selectivity. The degradation rate of tetracycline with IM-BTOM was nearly three times that with the conventional cellulose acetate spin coating membrane. Meanwhile, the existence of imprinting cavities also endowed IM-BTOM with high selectivity for the target pollutant, with a selectivity coefficient of up to 2.66. This work provides a new idea for preparing high-efficient photocatalytic membrane by spin coating.