材料科学
热电效应
微晶
塞贝克系数
高分辨率透射电子显微镜
拉曼光谱
分析化学(期刊)
X射线光电子能谱
烧结
掺杂剂
兴奋剂
热电材料
化学工程
纳米技术
冶金
热导率
光电子学
复合材料
化学
光学
工程类
透射电子显微镜
物理
热力学
色谱法
作者
Komal Singh,Ajit Kumar Roy,Bhasker Gahtori,Paritosh Dubey,Suman K. Mishra
出处
期刊:
[American Chemical Society]
日期:2023-11-14
卷期号:1 (11): 2954-2964
被引量:6
标识
DOI:10.1021/acsaenm.3c00453
摘要
Researchers are focused on developing an efficient and eco-friendly thermoelectric material, which has increased interest in tin selenide (SnSe). This study optimizes the sintering temperature ( T s ) for polycrystalline SnSe fabrication through a powder metallurgy process. It also explores the potential benefits of using Zn as a nontoxic dopant to enhance its thermoelectric properties. The detailed analyses of the data generated from XRD, SEM, EDS, Raman spectroscopy, XPS, high-resolution TEM (HRTEM), and thermoelectric properties measurement techniques were used to optimize the sintering temperature and understand the impact of doping concentration for polycrystalline SnSe. The optimized T s for SnSe was 600 °C on the basis of phase formation and the highest ZT value (∼0.55 at 772 K). A transition from n-type to p-type in the Seebeck coefficient data at T s < 600 °C was observed because of the dominant effect of tin oxide over SnSe, which was suppressed with the formation of SnSe with increasing measured temperatures. The addition of Zn to SnSe led to a boost in its ZT value by curbing thermal conductivity through the creation of a ZnSe second phase in Sn 0.95 Zn 0.05 Se, which resulted in an impressive ZT value of 1.05 at 783 K. The obtained ZT value, i.e., 1.05 at 783 K, is 91% higher than the undoped polycrystalline SnSe and found to be the maximum among the reported ZT values for Zn-doped SnSe (bulk, polycrystalline). The maximum voltage (∼241.5 mV at 425 °C) generated from the Zn (0.05)-doped SnSe was 57% more than that generated from the undoped SnSe.
科研通智能强力驱动
Strongly Powered by AbleSci AI