电容器
电容
电子工程
功率因数
转换器
涟漪
电气工程
平滑的
电解电容器
功率(物理)
计算机科学
工程类
电压
物理
电极
量子力学
计算机视觉
作者
Douglas Camponogara,Diogo Ribeiro Vargas,Marco A. Dalla Costa,J.M. Alonso,Joaquín J. García,Tiago Bandeira Marchesan
出处
期刊:IEEE Transactions on Industrial Electronics
[Institute of Electrical and Electronics Engineers]
日期:2015-01-01
卷期号:62 (1): 184-192
被引量:86
标识
DOI:10.1109/tie.2014.2327591
摘要
This paper presents a new control method and a detailed project methodology for the optimized connection method of two converters, aiming to reduce the redundant power processing, in order to supply high-power light-emitting diodes (LEDs) with reduced capacitance and high efficiency, directly from the ac line. This connection method allows dealing with two major issues related to the LED driver: capacitance reduction and efficiency increasing. The first converter provides power factor correction, whereas the second converter controls the current through the LED. The basic idea consists in making the second converter to process only the low-frequency ripple (LFR) of the first converter, thus smoothing the LED current. In this way, the LFR is managed by the second stage, so that the capacitance of the first stage can be significantly reduced. The proposed control method can achieve better results for the low-frequency compensation. In addition to that, a high power factor and a low harmonic content are obtained, fulfilling the IEC 61000-3-2 Class C requirements. A laboratory prototype with a rated power of 75 W and an input voltage of 220 V rms /60 Hz was built in order to show the feasibility of the idea. The measured overall efficiency of the converter was 91%, and electrolytic capacitors were avoided.
科研通智能强力驱动
Strongly Powered by AbleSci AI