Effects of Apical Barriers and Root Filling Materials on Stress Distribution in Immature Teeth: Finite Element Analysis Study

Purpose A finite element analysis (FEA) study was performed to determine whether the material of apical barrier used for root apexification and/or the use of canal reinforcement affect the stress distribution in an endodontically treated immature permanent tooth in order to infer in which clinical scenarios a fracture is more likely to occur based on the ultimate tensile strength threshold of dentin. Methods and Materials An extracted human immature mandibular premolar was selected as the reference model and scanned by micro-computed tomography (micro-CT). The digital model was segmented and converted to STL (Standard Tessellation Language) using Simpleware Scan-IP and exported in IGES (Initial Graphics Exchange Specification) to Ansys 19. Six experimental models were designed with different combinations of composite, mineral trioxide aggregate (MTA), and Biodentine (BIO). Using FEA, a static 300 N load at a 135 angle with respect to the axis of the tooth was applied to each model and von Mises stress values (MPa) were measured at the sagittal, apical 8-mm, 5-mm, 2-mm, and 1-mm levels. Results In all regions examined, the control (NT model) had lower stress in the root compared WITH experimental models. At the mid-root level, models with composite, MTA, and BIO reinforcement exhibited lower stresses in the root dentin than those with pulp or gutta-percha. BIO models had equal or greater average von Mises stress values than those of MTA models in all regions. Both, MTA and BIO, caused increases in stress of surrounding root dentin, with BIO causing a greater increase than MTA. Conclusions Stress distribution in immature permanent teeth treated by apexification is affected by the types of materials used. Root dentin's stress was lower when the mid-root canal was reinforced by composite, MTA, or BIO, which provided similar stress reduction to the root dentin. MTA is a more favorable apical barrier material from a mechanical standpoint because it induces less stress on apical root dentin than BIO.