摘要
The aviation industry is considering alternative fuels to reduce its dependency on fossil-derived jet fuel, and to mitigate environmental impacts of the latter.Governing bodies have set ambitious goals for the implementation of renewable fuels into the aviation industry and infrastructure.This study aims to investigate the possibility of utilizing fast pyrolysis followed by bio-oil upgrading, via hydrotreating, to produce an aromatic-rich renewable jet fuel.The study consists of two sections: an experimental fast pyrolysis section where the influence of pre-treatment and processing factors on product yields, bio-oil quality and bio-oil characteristics were investigated and a modelling section, where literature data was used to develop a simulation for a fast pyrolysis and hydrodeoxygenation process, using Aspen Plus®.The mass and energy balances from the simulation were used to estimate product yields, utility requirements and waste products.Fast pyrolysis screening experiments utilized a 2 3 experimental factorial design with different levels of particle size, biomass moisture content and pyrolysis reactor temperature over ranges of 0.25 -2mm, 3% -10% (wet basis) and 450-500 o C respectively.Chars were analysed with ultimate analysis and proximate analysis.Bio-oils were analysed using ultimate analysis, Karl Fischer, viscosity analysis, quantified GC-MS, 13 C NMR and 1 H NMR. Design Expert® was used to perform statistical analyses on the results to determine whether the process parameters had a significant effect on product yield and bio-oil quality.From the results, the optimal point of operation for transportation fuel production, that will require the least upgrading treatment, could be identified.Optimal conditions were identified based on a high organic yield and a high quality bio-oil best suited for fuel, with the most important criteria as: the higher heating value (HHV), a low acid content, a low aldehyde content and a low pyrolytic water content.Particle size had a significant influence on the organic liquid yield, with a small particle size increasing the organic liquid yield.Temperature did not have a statistically significant influence on the organic liquid yield.However, operation at a high temperatures and low biomass moisture contents did improve the quality of the bio-oil.Maximum bio-oil yield and quality was achieved at small particle sizes, low moisture contents and high temperatures.The screening experiment results were used in conjunction with literature ranges to guide to a selection of preferred operating conditions for the fast pyrolysis unit in the simulation.Literature reports on experimental studies producing hydrodeoxygenated bio-oils that are close to jet fuel specifications were limited, with details of processing conditions, especially temperature, pressure, yields and catalysts, often not reported fully within a particular study.Therefore, a combination of available literature was used to develop a simulation model to describe all the steps in the conversion process.The simulation consisted of a fast pyrolysis unit, followed by a hydrodeoxygenation and distillation unit.The simulation also included auxiliary units for hydrogen production, heat recovery, steam production and electricity generation.A pinch point analysis was performed for heat integration.The plant capacity was 92 dry tons/h of biomass feed.Mass balances showed that the aromatic yield in the jet fuel boiling range was only 0.76wt% (dry biomass basis).Furthermore, a jet fuel yield of 3.7wt% (dry biomass basis) was obtained, indicating that the process was not selective towards jet fuel production.The other fuels produced included naphtha, diesel and gas oil, at yields of 4.9wt%, 3.5wt% and 2.3wt% (dry biomass basis) respectively.