Evaluation of Cation and Backbone Chemistries for Electrospun and Crosslinked Nanofiber Composite Anion Exchange Membranes

聚砜 膜 离聚物 化学工程 静电纺丝 纳米纤维 离子交换 材料科学 氢氧化物 高分子化学 聚合物 电导率 化学 复合材料 有机化学 离子 共聚物 工程类 物理化学 生物化学
作者
Andrew Michael Park,Ryszard J. Wycisk,Forbes Ellington Turley,Peter N. Pintauro
出处
期刊:Meeting abstracts [Institute of Physics]
卷期号:MA2014-02 (21): 1281-1281
标识
DOI:10.1149/ma2014-02/21/1281
摘要

Introduction The anion exchange membrane fuel cell (AEMFC) has been the subject of increasing research since the mid-2000s, because its alkaline working environment does not require platinum to catalyze the rate-limiting oxygen reduction reaction. Identifying a benchmark membrane with high hydroxide ion conductivity that is strong and ductile with good chemical stability continues to be a primary objective of AEMFC research. Park and Pintauro have demonstrated that a dual-fiber electrospinning method can produce a membrane with both good conductivity and robust mechanical properties [1]. A crosslinking step was successfully introduced which allowed for the use of very high IEC ionomers with no water solubility issues [2]. In both studies, the ionomer was a polysulfone with tetramethyl ammonium fixed charge sites and the uncharged polymer was polyphenylsulfone. In this presentation, a series of different anion exchange membrane compositions and structures, based on dual nanofiber electrospinning, will be described in terms of the method for membrane preparation and the properties of the final film. For all membranes, an interconnected network of ionomer fibers will be embedded in an uncharged polymer matrix where the relative amounts of each component are varied. The ionomer fibers will employ either a crosslinked polysulfone or crosslinked poly(phenylene oxide) backbone polymer with either tetramethyl ammonium, 1-methylimidazolium, or 1,2-dimethylimidazolium fixed charge cations. Each film was evaluated in terms of room temperature in-plane hydroxide ion conductivity, gravimetric water swelling, mechanical properties, and chemical stability in hot water and hot 1M KOH solution. Experimental Commercial UDEL® P-3500 polysulfone (PSF, MW = 83,000 g/mol, from Solvay) was chloromethylated/iodomethylated and poly(phenylene oxide) (PPO, MW = 30,000 g/mol, from Sigma Aldrich) was brominated using standard procedures. These functionalized polymers were used as ionomer precursors in the nanofiber composite membrane fabrication scheme. The uncharged reinforcing polymer for the composite films was RADEL® poly(phenylsulfone) (PPSU, MW = 60,000 g/mol, from Solvay). Electrospun fibers of either brominated PPO or chloromethylated/iodomethylated PSF were crosslinked with either 1,6-hexanediol or hexamethylenediamine [2]. After crosslinking, fiber mats were exposed to chloroform vapor which softened the PPSU fibers and allowed them to fill the void space around ionomer fibers, thus forming a dense and defect-free membrane. Film soaking in solutions of trimethylamine, 1-methylimidazolium, or 1,2-dimethylimidazolium converted the films into anion exchange membranes with a specific type of fixed charge group. Membranes were soaked in 1 M KOH and then in de-gassed water before testing. Results and Discussion Four membranes of different compositions are listed in Table 1. The effective IEC of the membranes (taking into account the uncharged PPSU material) ranged from 1.8-2.3 mmol/g. Crosslinking prevented ionomer dissolution in water. All membranes were mechanically robust in the wet and dry states. Table 1 – Properties of nanofiber composite AEMs in water at 25oC Sample Ionomer Fiber IEC (mmol/g) In-plane Conductivity (mS/cm) Gravimetric Swelling (%) 1 2.80 52 118 2 3.11 65 144 3 3.58 72 152 4 3.65 58 95 Sample 1: Diol-crosslinked polysulfone/PPSU; 65 wt.% ionomer with tetramethyl ammonium groups Sample 2: Diamine-crosslinked polysulfone/PPSU; 65 wt.% ionomer with tetramethyl ammonium groups Sample 3: Diamine-crosslinked PPO/PPSU; 65 wt.% ionomer with 1,2-dimethylimidazolium groups Sample 4: Diamine-crosslinked PPO/PPSU; 50 wt.% ionomer with tetramethyl ammonium groups References 1. Park, A. M.; Pintauro, P. N. Electrochem. Solid State Lett. 2012, 15, B27 2. Park, A.M.; Turley, F.E.; Wycisk, R.J.; Pintauro, P.N. Macromolecules, 2014, 47 (1), 227. Acknowledgements This work is supported by the National Science Foundation (Grant CBET-1032948) and by the Army Research Office (Contract No. W911NF-11-1-0454).

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
Voiceless的应助被Bin_Liu采纳,获得10
3秒前
不吃压力就是干完成签到 ,获得积分10
3秒前
Lingeek完成签到,获得积分10
8秒前
霸气芫完成签到 ,获得积分10
12秒前
12秒前
betty2009完成签到,获得积分10
13秒前
饱满千兰完成签到,获得积分10
14秒前
科研通AI6.3的应助被u雨采纳,获得10
18秒前
王kk完成签到 ,获得积分10
19秒前
哈哈哈完成签到 ,获得积分10
21秒前
邓代容完成签到 ,获得积分0
26秒前
奋斗诗云完成签到 ,获得积分10
28秒前
irisyan完成签到 ,获得积分10
30秒前
白云完成签到 ,获得积分10
31秒前
难过的研究牲完成签到 ,获得积分10
32秒前
大耳朵图图完成签到 ,获得积分10
33秒前
孤狼完成签到 ,获得积分10
37秒前
子良完成签到 ,获得积分10
37秒前
xinxin完成签到 ,获得积分10
38秒前
黑白完成签到 ,获得积分10
38秒前
一诺相许完成签到,获得积分10
40秒前
领导范儿的应助被文文采纳,获得10
42秒前
xh完成签到,获得积分10
43秒前
QwQ完成签到 ,获得积分10
44秒前
高兴的灰狼完成签到,获得积分20
44秒前
科研猫完成签到,获得积分10
45秒前
nanting完成签到 ,获得积分10
48秒前
momo完成签到,获得积分10
51秒前
求知小生完成签到 ,获得积分10
53秒前
Ava完成签到,获得积分10
54秒前
55秒前
冷傲的婷冉完成签到,获得积分10
57秒前
Ayun完成签到,获得积分10
57秒前
58秒前
Ayun发布了新的文献求助10
1分钟前
爱听歌的香萱完成签到,获得积分10
1分钟前
翰飞寰宇完成签到 ,获得积分10
1分钟前
wangji_2017发布了新的文献求助10
1分钟前
甘sir完成签到 ,获得积分0
1分钟前
1分钟前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
John McDowells Bildungstheorie 800
Social Psychology in the Real World 600
八旗制度の研究 600
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8180068
求助须知:如何正确求助?哪些是违规求助? 9570224
关于积分的说明 21808724
捐赠科研通 7776054
什么是DOI,文献DOI怎么找? 3433261
关于科研通互助平台的介绍 2557425
邀请新用户注册赠送积分活动 2479012