Molecular Simulation of Cyclohexane in Nanoporous Materials: Adsorption of Conformers and Coadsorption with Water and Carbon Dioxide

Molecular simulation is used to investigate the adsorption of an organic molecule and its different conformers into various nanoporous adsorbents. In more detail, we perform grand canonical Monte Carlo simulations to determine the adsorption isotherms for cyclohexane with its three conformers (chair, boat, and twisted boat) at three different temperatures into a molecular model of active carbons and two metal-organic frameworks (MOFs) (Cu-BTC and Al-Fum). By considering the adsorption of each conformer separately, we show that the adsorption isotherms are weakly dependent on the molecular conformation. When considering the concomitant adsorption of the three conformers under realistic conditions (to verify the population of each conformer in bulk mixtures), we show that the chair conformer is predominantly adsorbed in each material. However, such favorable adsorption mostly reflects the fact that this conformer has the largest population in the bulk mixture under the same thermodynamic conditions. On the contrary, with an increase in the cyclohexane gas pressure, the adsorption of boat and twisted boat conformers increases, while that of the chair conformer decreases as packing (entropy) effects become predominant during confinement. The adsorption of cyclohexane in the active carbon and MOF materials is also considered in the presence of water and CO₂ atmospheres. In the case of the Al-fumarate material, the material is found to be strongly organophilic so that water and CO₂ adsorption are negligible, and cyclohexane adsorption is not affected by competitive adsorption under any considered thermodynamic condition. On the contrary, for the active carbon and Cu-BTC material, competitive adsorption between cyclohexane and water or CO₂ is observed even if cyclohexane adsorption remains preferred. While the different molecules coexist in the adsorbed phase at low pressures, increasing the cyclohexane pressure beyond 10³ Pa promotes cyclohexane adsorption concomitantly with water and/or CO₂ desorption.