Interfacial and emulsion characterisation of chemically modified polysaccharides through a multiscale approach

The structural modification of natural emulsifiers may greatly impact their interfacial behaviours and bulk properties. The relationship between the microscopic interfacial viscoelasticity and the macroscopic emulsion stability in emulsifiers with different degrees of modification can be clarified using a multiscale approach. A polysaccharide emulsifier of corn fibre gum (CFG) with different octenyl succinate anhydride (OSA) contents was used to obtain a broad variety of interfacial properties. Interfacial adsorption kinetics and viscoelastic responses were measured by combining interfacial shear rheology and quartz crystal microbalance with dissipation monitoring, and the emulsion properties (droplet size and physical stability) at other scales were evaluated. Compared with native CFG, esterified CFG formed thick interfacial films with higher elasticity and viscosity, and their corresponding emulsions showed greater stability. There exists a satisfactory correlation between interfacial rheological properties and emulsion stability. However, such a satisfactory correlation can not be established among the degree of esterification of CFG, interfacial viscoelasticity and stability since depletion flocculation might occur in the emulsion stabilized by the OSA-CFG with the highest OSA content, which induced inferior bulk stability but exerted no impact on the measured interfacial properties. We propose that the depletion flocculation is responsible for this imperfection and provide detailed explanations.