点蚀
材料科学
腐蚀
合金
冶金
电化学
机制(生物学)
电极
化学
物理化学
认识论
哲学
作者
H. Herrera-Hernández,Araceli Mandujano Ruíz,Carlos Morán,José G. Miranda‐Hernández,José de Jesús Agustín Flores Cuautle,Jorge Morales Hernández,Irma Hernández Casco
出处
期刊:Materials
[Multidisciplinary Digital Publishing Institute]
日期:2024-06-20
卷期号:17 (12): 3044-3044
被引量:6
摘要
Sulfuric acid anodizing assisted by a hydrothermal sealing with inhibitors [Ce3+-Mo6+] was used to prevent pitting corrosion on spray-deposited hypereutectic Al–Si alloy (A390). An investigation concerning the evaluation of pitting corrosion resistance on the anodic oxide thin film with ions incorporated was carried out in NaCl solution using electrochemical measurements (i.e., potentiodynamic polarization and electrochemical impedance spectroscopy, EIS). The influence of Si phase morphology and size on the growth mechanism of an anodic oxide film was characterized by scanning electron microscopy (SEM) and X-ray diffraction (XRD). The results were then compared with those for its equivalent IM390 alloy (Al-17Si-4.5Cu-0.6Mg) produced through a conventional process ingot metallurgy, IM. The electrochemical findings indicate that sulfuric acid anodizing followed by a simple hot water sealing treatment was ineffective. In this manner, an intense attack was localized by pitting corrosion that occurred on the anodic oxide film in less than three days, as denoted by characteristic changes in the EIS spectra at the lowest frequencies. Improved results were achieved for Ce–Mo surface modification, which can provide better corrosion resistance on the aluminum alloys because no signs of pits were observed during the corrosion testing.
科研通智能强力驱动
Strongly Powered by AbleSci AI