Tuning Stainless Steel Oxide Layers through Potential Cycling─AEM Water Electrolysis Free of Critical Raw Materials

Anion exchange membrane water electrolyzers (AEMWEs) have an intrinsic advantage over acidic proton exchange membrane water electrolyzers through their ability to use inexpensive, stable materials such as stainless steel (SS) to catalyze the sluggish oxygen evolution reaction (OER). As such, the study of active oxide layers on SS has garnered great interest. Potential cycling is a means to create such active oxide layers in situ as they are readily formed in alkaline solutions when exposed to elevated potentials. Cycling conditions in the literature are rife with unexplained variations, and a complete account of how these variations affect the activity and constitution of SS oxide layers remains unreported, along with their influence on AEMWE performance. In this paper, we seek to fill this gap in the literature by strategically cycling SS felt (SSF) electrodes under different scan rates and ranges. The SSF anodes were rapidly activated within the first 50 cycles, as shown by the 10-fold decline in charge transfer resistance, and the subsequent 1000 cycles tuned the metal oxide surface composition. Cycling the Ni redox couple (RC) increases Ni content, which is further enhanced by lowering the cycling rate, while cycling the Fe RC increases Cr content. Fair OER activity was uncovered through cycling the Ni RC, while Fe cycling produced SSF electrodes active toward both the OER and the hydrogen evolution reaction (HER). This indicates that inert SSF electrodes can be activated to become efficient OER and HER electrodes. To this effect, a single-cell AEMWE without any traditional catalyst or ionomer generated 1.0 A cm-2 at 1.94 V ± 13.3 mV with an SSF anode, showing a fair performance for a cell free of critical raw materials.