溶解
氮化硅
硅酸盐
硅
材料科学
氮化物
熔渣(焊接)
陶瓷
溶解度
无机化学
扩散
硅酸钙
矿物学
分析化学(期刊)
离子
冶金
化学
图层(电子)
物理化学
热力学
色谱法
复合材料
有机化学
物理
作者
Shoichirou Taira,Kunihiko Nakashima,Katsumi Mori
标识
DOI:10.2320/jinstmet1952.59.5_540
摘要
Dissolution rates of silicon nitride ceramics into CaO-SiO2-10 mass%Al2O3 slags were measured by rotating specimen method. Experiments were conducted at various revolution speeds, temperatures, and CaO/SiO2 ratios. Moreover, the solubility of Si3N4 into the slags were measured to calculate the mass transfer coefficients of Si3N4. Based on these results, the dissolution mechanism of silicon nitride into the slags was discussed.The dissolution rate of silicon nitride ceramics increased with increasing revolution speed and rising temperature. These results suggested that the dissolution rate was controlled by mass transport in the boundary layer of molten slags. The dissolution rate of silicon nitride increased slightly with increasing CaO/SiO2 ratios. This increase of the dissolution rate is attributed to the increase of the diffusivity of the solute accompanied with the decrease of slag viscosity with CaO/SiO2 ratios.The chemical analysis of the slags after immersing silicon nitride ceramics showed that almost nitrogen in slags existed as N3− ions. On the other hand, the quantity of CN− ions was negligible, though the existence of CN− ions was confirmed. From the estimation of the interdiffusion coefficient DCaO-Si3N4 in the molten slags using JD-factor, it was found that DCaO-Si3N4 was a little smaller than DCaO-SiO2. From this result, it was reasonable that N3− ions existed in the molten slags incorporated into silicate network such as silicate complex anion. These results showed that the dissolution of silicon nitride proceeded by the diffusion of the N3− ion incorporated into silicate anions.
科研通智能强力驱动
Strongly Powered by AbleSci AI