摘要
Sidestreams within municipal wastewater treatment processes, or reject water, are known to contain high concentrations of nutrients. Centrate, for example, is the liquid fraction separated from solids during sludge dewatering, an essential step in wastewater treatment. Centrate contains high ammonium (NH₄ + ) concentrations, typically ranging from 800–1600 ppm, which contribute to eutrophication and nitrous oxide emissions when improperly handled. Meanwhile, global ammonia production remains strongly coupled to the energy- and carbon-intensive Haber-Bosch process. More than half of the ammonia used in the United States is ultimately lost to wastewater, representing both a significant economic loss and a major opportunity for nutrient recovery. Direct ammonium recovery from wastewater therefore presents a dual benefit: mitigating nutrient pollution while displacing greenhouse-gas-intensive fertilizer production. However, existing treatment technologies often rely on substantial chemical inputs or membrane-based separations, limiting scalability and operational durability. To address these challenges, Roca Water is developing a modular, membrane-free electrochemical system based on ion-intercalation electrodes for selective ammonium capture and recovery. The platform employs Prussian Blue Analogue (PBA) electrodes, where ion selectivity is governed by the crystal structure and redox chemistry of the electrode rather than membranes or chemical additives. During electrochemical reduction, NH₄ + is selectively intercalated into the electrode from the waste stream. Subsequent oxidation releases NH₄ + into a recovery electrolyte, enabling the production of concentrated ammonium solutions suitable for downstream fertilizer use. This presentation will highlight the ongoing development of a continuous electrochemical flow-cell process designed to increase throughput while generating more concentrated ammonium product streams. Initial studies in three-electrode batch cells were used to characterize ion-selective intercalation behavior, evaluate electrode capacity and durability in real and synthetic wastewater (SWW) matrices, and quantify NH₄ + selectivity. Using an Ag/AgCl reference electrode and an activated carbon counter electrode, NiHCF electrodes were tested in sodium-rich SWW containing various concentrations of NaCl and NH₄Cl, as summarized in the attached table. When cycled galvanostatically at 1C, the electrodes maintained capacities above 50 mAh/g with less than 3% capacity fade over 200 cycles. Furthermore, selectivity experiments performed in these sodium-rich solutions demonstrate strong preferential NH₄ + intercalation, with selectivity coefficients of 9 and above. Together, these results establish a foundation for process scale-up by demonstrating minimal capacity fade and high NH₄ + /Na + selectivity, even under unfavorable ammonium concentration conditions. Building on these results, a two-electrode electrochemical flow-cell system is currently under development to emulate a prototype device and continuous treatment process. The system integrates automated solution handling and galvanostatic cycling to transfer ammonium from a feed solution into a product stream over successive cycles. Automated operation enables longer-duration experiments with improved repeatability relative to manual batch testing, supporting higher achievable concentration differentials and more representative process evaluation. The modular, stacked-cell architecture accommodates a wide range of electrode sizes within a compact internal volume, allowing independent control of treated solution volume and final product concentration. Ongoing work is benchmarking flow-cell performance using capacity, durability, and selectivity metrics, and evaluating system-level indicators such as energy per mole of ammonium recovered, product purity, and key design and operational tradeoffs relevant to scaling electrochemical ammonium recovery for practical wastewater applications. Figure 1