Research on noise reduction of drive axle hypoid gear based on tooth surface mismatch modification

In order to reduce the transmission noise of drive axle hypoid gear, a method of tooth surface mismatch modification was proposed. Firstly, on the basis of establishing the grinding mathematical model of hypoid gear with cutter tilt, the theoretical tooth surface equation was derived, and the numerical tooth surface was calculated by dividing the grid points on tooth surface. Secondly, the pinion tooth surface which was full conjugated with gear tooth surface was constructed, and the tooth surface mismatch topography was established and decomposed into the first order and second order mismatch coefficients. According to the modification requirements, the pinion target surface was constructed by modifying the tooth surface mismatch coefficients, and the pinion modified machine setting parameters were acquired by establishing the pinion processing parameters corrected mathematical model. Finally, the loaded tooth contact analysis with finite element simulation and drive axle NVH (Noise, Vibration, Harshness) simulation were carried out for a pair of hypoid gear, therefore the loaded tooth contact areas, transmission errors curves, and noise simulation curves were obtained, and the simulation results show that after modification the tooth contact stress, loaded transmission errors amplitude, and NVH simulation curves value are all reduced. The road test results indicate that the drive axle hypoid gear howling phenomenon under the high speed operation can be eliminated, so the effectiveness of tooth surface modification method and NVH simulation method were verified.