电缆管道
球(数学)
刚度
有限元法
计算
结构工程
方位(导航)
空气轴承
滚珠轴承
数值分析
推力轴承
流离失所(心理学)
刚体
变形(气象学)
机械
材料科学
推力
工程类
几何学
数学
物理
机械工程
经典力学
复合材料
数学分析
心理治疗师
润滑
心理学
算法
天文
作者
Samy Lacroix,Daniel Nélias,Alexandre Leblanc
标识
DOI:10.1080/10402004.2015.1017894
摘要
When a ball bearing is designed with thin rings or is mounted in a flexible housing, the assumption of rigid rings is not true anymore. In this article, an experimental study is presented and a comparison with a numerical model is performed. The numerical approach is based on the coupling between a semi-analytical code and a finite element (FE) model that computes the deformation of the rings and housings. The numerical model accounts for ring ovalization, raceway opening, change of conformity, and structural displacements of the whole assembly. The experimental setup allows investigation of the load–displacement behavior of a four-point contact ball bearing submitted to a static thrust loading. Displacements are measured by an optical method (stereo-correlation) that enables comparison of the surface deformation of the two tested bearings and computation of the rigid-body displacement of the inner ring with respect to the outer ring. A comparison between experimental results, numerical results, with and without consideration of ring and housing stiffness, is presented. The numerical results show the importance of the housing stiffness in the modeling, even with standard ball bearings with relatively large and thick rings. Good agreement between measured quantities and numerical results was found. This permits the prediction of the real nonlinear bearing stiffness (load–displacement curve) with a reasonable margin of error.
科研通智能强力驱动
Strongly Powered by AbleSci AI