Multilayer polyester tire cord fabrics reinforced gamma irradiated SBR/devulcanized waste rubber: impact of fabric layers and devulcanization methods

Purpose This study aims to investigate the influences of polyester fabric layers on the mechanical properties of SBR and devulcanized waste rubber composite materials, as well as the effect of gamma irradiation dose. Design/methodology/approach The devulcanized waste rubbers (DWR) were carried out by different methods. First, chemically, by two different reclaiming agents such as tetramethylthiuram disulfide (TMTD) and 2-mercapto benzothiazole disulfide (MBTS). Secondary by a physical method like microwave (MW). The devulcanized rubbers were mixed with virgin styrene butadiene rubber (SBR) in different ratios, as follows: SBR-DWR (TMTD) 50 / 50, SBR-DWR (MBTS) 80 / 20 and SBR-DWR (MW) 80 / 20. A series of sandwich polyester tire cord fabrics were used as reinforcement for making SBR and devulcanized waste rubber composite materials and molded on a hot press into rubber sheet films, then subjected to gamma radiation at different doses ranging from 100 up to 200 kGy. Findings The experimental results indicate that increasing the layer number improves the mechanical properties of composites. The tensile strength, tearing, hardness and elastic modulus of the rubber composites increased with the rise of the fiber layers and by increasing the irradiation dose up to 200 kGy. The reclaiming agent TMTD gave the best results for mechanical properties, followed by MW and then MBTS. Originality/value This phenomenon can be detailed based on the fact that when the fiber-reinforced composites are subjected to loading, the fibers act as load carriers, depending on the population and orientation of the fibers. Also, scanning electron microscopy (SEM) reveals that adhesion was caused by tire cord fabrics and rubber blend matrix.