Additive manufacturing of short fiber oxide ceramic matrix composite: Process analysis and material properties

Abstract This work investigates the material extrusion‐based additive manufacturing (AM) process chain of a pure alumina‐based oxide ceramic matrix composite, starting from material selection, large‐scale compounding to pellets, the AM process itself, debinding and sintering as well as microstructural and mechanical characterization. The compounded pellets have a volume share of 50% binder (polyvinyl butyral [PVB], polyethylene glycol [PEG], and stearic acid) and 50% alumina (Al 2 O 3 , alumina powder, and Nextel 610 alumina fibers) with an aimed fiber volume share of 40% after sintering. The material is compounded on an industrial scale with approximately 10 kg/h and the material extrusion‐based AM process reaches speeds of up to 1000 mm/s. A variation of the feed rate leads to a significant increase in surface roughness and an increase in mass of 30%, in thickness of 12% and in width of 25%. The flexural behavior in the four‐point‐bending test can be described by a fast first peak and reaching higher flexural strength after the first crack subsequent with averages of 23.8 ± 3.6 MPa below .1% elongation. The fracture surfaces show the expected failure mechanisms like pull‐out and crack deflection. The resulting fiber length in the printed samples is 140 µm in average.