蜡烛
催化裂化
过滤(数学)
tar(计算)
滤波器(信号处理)
化学工程
莫来石
蒸发器
陶瓷
材料科学
木材气体发生器
废物管理
化学
工艺工程
开裂
复合材料
热交换器
工程类
机械工程
有机化学
煤
电气工程
统计
程序设计语言
计算机科学
数学
作者
Eleonora Simeone,Emilie Hölsken,Manfred Nacken,Steffen Heidenreich,Wiebren de Jong
标识
DOI:10.2202/1542-6580.1983
摘要
Solid particles and tars are among the non-desirable products of synthesis gas produced during biomass gasification. Removal of fly ashes is necessary in order to comply with emission limits as well as avoid their deposition in downstream units. Condensation of tars, on the other side, can cause clogging. A catalytic hot gas filter can remove both solids and tars, when operating at temperatures as high as 850°C. Catalytic hot gas filter elements are under development in order to solve this issue.A lab-scale filtration unit has been designed and constructed at Delft University of Technology. The unit contains one ceramic hot gas filter candle which is made of a SiC porous structure coated with a mullite membrane. The integration of a Nickel-based catalyst layer allows the dual function of particle filtration and tar cracking. The filter vessel is part of a set-up that is equipped with a tar evaporator and a pre-heater, both located upstream of the filter unit.This paper presents the results of the first set of experimental tests that have been performed with this unit. A dust-free model gas was used and consisted of a mixture of CO (14%), CO2 (14%), H2 (7%), CH4 (5%), and varying concentrations of N2 (30, 40, 50%) and H2O (30, 20, 10%). Naphthalene (varying concentrations up to 9 g/Nm3) was adopted as model compound in order to study the catalytic conversion of heavier hydrocarbon species to H2. A gas face velocity of 2.5 cm/s and 3 cm/s was selected for tests performed at atmospheric conditions and at operating temperatures varying between 700 °C and 850 °C. The pressure drop through the filter candle was continuously monitored during the process. The gas composition was measured upstream and downstream of the filter unit by means of an on-line micro-GC, while naphthalene concentration was attained with the SPA method.The following findings were obtained: higher naphthalene conversion with increasing temperatures and better conversion at any temperature with lower concentrations. Tests at 850°C and 30 vol% H2O produced a conversion of 99.4% with 2.5 g/Nm3 while 98.5% with 7.8 g/Nm3. Experiments with higher steam content showed higher conversion values. Methane concentration was also affected thus indicating that reforming reactions took place as well. Low toluene concentration was detected as a product of the reactions while no benzene was identified.
科研通智能强力驱动
Strongly Powered by AbleSci AI