High Accuracy Software-Based Clock Synchronization Over CAN

In distributed real-time communication systems, common knowledge of the global time is crucial. It prevents message violations on the bus and allows independent components to collaborate within a real-time system on a timely basis. Systems with hard real-time requirements need to have high precision and accuracy of time. This is achieved by hardware-supported frame time-stamping mechanisms as found in dedicated protocols, such as time-triggered CAN (TTCAN), Flexray, and time-sensitive networking (TSN)-enabled Ethernet. However, many microcontroller units are not specifically designed to provide such a hardware-based solution at the communication interface. Therefore, a software-based implementation of the time synchronization algorithm is needed. Nevertheless, some commercial off-the-shelf (COTS) microcontroller units already provide an IEEE 1588-enabled Ethernet interface, including a high-precision timer module with rate correction. This module can be used for time synchronization purposes to align a set of distributed clocks via various communication interfaces. This article investigates the accuracy of software-based and hardware-supported time synchronization algorithm over the controller area network (CAN) protocol using a COTS microcontroller. As a result, we present identified jitter and delay sources as well as the achieved time accuracy. We show that using an advanced timer module combined with additional system knowledge allows submicrosecond precision and accuracies.