Elastic Critical Buckling Coefficients for Skew Plates of Steel Structures under Biaxial Normal Stress

In steel structures, skew thin steel plates serve as panel zones in structures spanning large spaces (e.g., warehouses and gymnasiums). Considerable research has been conducted on the shear buckling of panels due to seismic loads acting on a structure. Conversely, under snow or wind loads, the panel zone may experience compressive and tensile stresses simultaneously from two directions. Considering the economic preference for thin steel plates, evaluating the elastic critical local buckling stresses in the panel zone under biaxial normal stress may provide essential information to structural engineers. In this study, an elastic buckling analysis based on the energy method is performed to clarify the impact of panel geometry and boundary conditions on the elastic local buckling stresses of skew panel zones. As confirmed from the results, the local buckling stresses calculated using the energy method were consistent with those determined using finite element analysis. The findings indicate that a skew angle of up to 30° marginally affects the elastic buckling stress under uniaxial stress. Consequently, engineer-friendly design formulas were developed based on these findings. Comparisons with previous research demonstrated that the buckling loads reported were generally higher than those determined by finite element analysis. The study also established the correlation of the buckling stresses under biaxial stresses, which implied that the skew angle posed minimal influence on buckling stress for skew plates under biaxial stress. Additionally, a method for evaluating this correlation was presented. Engineers can utilize the provided design equations to more efficiently and accurately calculate buckling loads, facilitating a safer and more economical design of structures with skew plates.