过电位
微观结构
材料科学
电化学
X射线光电子能谱
成核
阳极氧化
氯化银
循环伏安法
氯化物
分析化学(期刊)
扫描电子显微镜
图层(电子)
无机化学
化学工程
冶金
复合材料
物理化学
化学
电极
有机化学
铝
工程类
色谱法
作者
Farhad Pargar,Hristo G. Kolev,Dessi A. Koleva,Klaas van Breugel
标识
DOI:10.1007/s10853-018-2083-0
摘要
Characterization of the Ag/AgCl electrode is a necessary step toward its application as a chloride sensor in a highly alkaline medium, such as concrete. The nucleation and growth of AgCl on Ag in 0.1 M HCl was verified through cyclic voltammetry. Ag anodization was performed at current densities, determined by potentiodynamic polarization in the same (0.1 M HCl) medium. The morphology and microstructure of the AgCl layers were evaluated via electron microscopy, while surface chemistry was studied through energy-dispersive spectroscopy and X-ray photoelectron spectroscopy. At current density above 2 mA/cm2, the thickness and heterogeneity of the AgCl layer increased. In this condition, small AgCl particles formed in the immediate vicinity of the Ag substrate, subsequently weakening the bond strength of the Ag/AgCl interface. Silver oxide-based or carbon-based impurities were present on the surface of the sensor in amounts proportional to the thickness and heterogeneity of the AgCl layer. It is concluded that a well-defined link exists between the properties of the AgCl layer, the applied current density and the recorded overpotential during Ag anodization. The results can be used as a recommendation for preparation of chloride sensors with stable performance in cementitious materials.
科研通智能强力驱动
Strongly Powered by AbleSci AI