平面激光诱导荧光
材料科学
燃烧室
激光器
温度测量
分析化学(期刊)
校准
激发
平面的
激发态
瑞利散射
激光诱导荧光
光学
燃烧
化学
原子物理学
电气工程
有机化学
工程类
计算机图形学(图像)
物理
统计
量子力学
色谱法
计算机科学
数学
作者
Chao Tao,Chi Zhang,Qiang An,Xin Xue
摘要
Abstract This paper investigates the temperature fields in a centrally staged swirl spray combustor using two-line OH planar laser induced fluorescence (PLIF) thermometry at elevated inlet pressures and temperatures up to 0.62 MPa and 650 K. The pilot and main stages of the combustor were supplied with RP-3 kerosene. OH radicals were excited using the Q1(5) and Q1(14) transitions within the A2Σ←X2Π (1,0) band. Two laser excitation systems were operated simultaneously, where the two beams were spatially combined and separated by a small interval in time. The PLIF signals excited at the two wavelengths were captured by two identical sets of imaging system. The calibration coefficient needed for quantitative conversion from fluorescence ratio to temperature was determined based on results from independent coherent anti-Stokes Raman scattering (CARS) measurements. A joint threshold mask was developed to remove the noise and weak signals in the raw PLIF images. The high temperature zones in the temperature field were then obtained, and the pilot and main stage flames were identified. In addition, the radial position of the pilot flame showed marked variations at a nominally fixed condition. By extracting the radial profiles, a consistency between the peaks of PLIF intensity and temperature was found, suggesting that PLIF images could be a qualitative substitute for the high temperature zones in the temperature fields of these swirl spray flames. This study demonstrates the feasibility of temperature field measurements using two-line OH PLIF in aero-engine model combustors.
科研通智能强力驱动
Strongly Powered by AbleSci AI