This paper investigates the contact angle obtained from wettability tests for smooth spherical glass particles with water by four techniques; (i) visual qualitative assessment at bulk level; (ii) modified sessile drop at bulk level; (iii) gel trapping technique at single particle level; and (iv) environmental scanning electron microscope (ESEM) at different locations on an individual particle. A deeper understanding of wettability is developed from bulk powder to surface heterogeneity over a single particle. Differences were observed between the contact angles (θ) for bulk and individual hydrophobic (silanised) and surfactant treated hydrophobic particles using the sessile drop and gel trapping techniques (GTT). The contact angle value (θ) is reported as 157degrees 2.25degrees for hydrophobic (silanised) particles and θ=118degrees 2.57degrees for surfactant treated silanised particles, as measured by the sessile drop technique. In contrast contact angle measurements made using the GTT were determined as 102degrees 1.6degrees for silanised particles and 95.2degrees 3.09degrees for surfactant treated silanised particles. For ESEM measurements on individual particles, contact angle was seen to vary across the surface of particles (θ=104degrees-130degrees for silanised particles; θ=60degrees-100degrees for surfactant treated silanised particles), suggesting inhomogeneity of the surfactant treatment. Measured contact angle results were consistent with qualitative visual assessment of powders dropped on to water; silanised powders remained clumped on the water surface and surfactant treated silanised particles dispersed over the water surface quickly and then sank.