材料科学
复合材料
摩擦学
冶金
涂层
变形(气象学)
焊接
沉积(地质)
工作(物理)
扫描电子显微镜
作者
Mehdi Rezaei,Hassan Elmkhah,Meisam Nouri,Esmaeil Damavandi,Ali Fallah-Lalehzari
标识
DOI:10.1016/j.rineng.2026.112814
摘要
This study investigates the effect of a pre-carburizing treatment on the high‑temperature tribological behavior of CrN/CrAlN nano-structured coatings performed on St52 steel. Solid pack carburizing was performed at 920 °C for three hours followed by quenching and tempering, then, CrN/CrAlN nano-structured coatings were deposited using a cathodic arc evaporation physical vapor deposition (CAE-PVD) technique. Characterization was carried out using XRD, FE‑SEM/EDS, microhardness, nanoindentation, coating adhesion (VDI 3198), surface roughness tests, and pin‑on‑disc tribology at room temperature, 250 °C, and 450 °C. Carburizing increased surface hardness from 262 HV to ∼458 HV, while duplex carburizing + PVD treatment achieved the highest hardness, nearly 5 times more than that of the substrate. Tribological tests revealed a major temperature‑dependent improvement for the duplex coating. At 450 °C, the wear track depth decreased dramatically from 16 µm for substrate reaching only 3 µm in pre-carburized CrN/CrAlN nano-structured coatings, corresponding to a ∼81% reduction in worn depth. Also, the specific wear rate of the duplex sample dropped to 0.5 × 10 -7 mm 3 /N.m, representing a 75% reduction relative to its room‑temperature 2 × 10 -7 mm 3 /N.m. Overall, integrating solid pack carburizing with nano-structured CrN/CrAlN coating significantly enhances substrate support, adhesion stability, and high‑temperature wear resistance, demonstrating the superiority of this duplex strategy for thermally demanding tribological applications.
科研通智能强力驱动
Strongly Powered by AbleSci AI