Protein–Protein Interactions during High-Moisture Extrusion for Fibrous Meat Analogues and Comparison of Protein Solubility Methods Using Different Solvent Systems

Soy protein, mixed with gluten and starch, was extruded into fibrous meat analogues under high-moisture and high-temperature conditions. The protein solubility of samples collected at different extruder zones and extrudates made with different moistures was determined by 11 extraction solutions consisting of 6 selective reagents and their combinations: phosphate salts, urea, DTT, thiourea, Triton X-100, and CHAPS. Protein solubility by most extractants showed decreasing patterns as the material passed through the extruder, but the solution containing all 6 reagents, known as isoelectric focus (IEF) buffer, solubilized the highest levels and equal amounts of proteins in all samples, indicating that there are no other covalent bonds involved besides disulfide bonds. With regard to relative importance between disulfide bonds and non-covalent interactions, different conclusions could be made from protein solubility patterns, depending on the type of extracting systems and a baseline used for comparison. The observation points out pitfalls and limitation of current protein solubility methodology and explains why controversy exists in the literature. Using the IEF buffer system with omission of one or more selective reagents is considered to be the right methodology to conduct protein solubility study and thus recommended. Results obtained with this system indicate that disulfide bonding plays a more important role than non-covalent bonds in not only holding the rigid structure of extrudates but also forming fibrous texture. The sharpest decrease in protein solubility occurred when the mix passed through the intermediate section of the extruder barrel, indicating formation of new disulfide bonds during the stage of dramatic increase in both temperature and moisture. After this stage, although the physical form of the product might undergo change and fiber formation might occur as it passed through the cooling die, the chemical nature of the product did not change significantly.