蜡
聚二甲基硅氧烷
聚丙烯
聚乙烯
材料科学
复合材料
渗透(战争)
化学工程
高分子化学
运筹学
工程类
作者
T. E. Karis,C. Mark Seymour
出处
期刊:Journal of Imaging Science and Technology
[Society for Imaging Science and Technology]
日期:1996-09-01
卷期号:40 (5): 462-471
被引量:2
标识
DOI:10.2352/j.imagingsci.technol.1996.40.5.art00016
摘要
Continuous improvements in printer resolution place greater demands on toner performance. As the pel size becomes smaller, the requirements for edge definition and the elimination of hot offset increasingly become limiting factors in determining print quality. Edge definition, resolution, and offset can be addressed to some extent by improved charge control for narrower charge distribution and elimination of wrong size toner. Another contribution to the offset lies in the adhesion of toner to the fuser roll and subsequent redeposition on the paper where it is not intended. This study evaluates wax internal release agents to determine which combinations of waxes and additives, including block copolymers and polydimethylsiloxane oils, provide the best release properties. Primarily the focus is on polyethylene and polypropylene waxes. There is little effect of polyethylene wax molecular weight on peel strength. Lowest peel strength is with polyethylene wax and polydimethylsiloxane oil. Lowest offset with little effect on tribocharging is with polypropylene wax and polydimethylsiloxane oil. Release properties are controlled by the distribution of release agent between surface and bulk as well as the dynamics of migration from the bulk to the surface. X-ray photoelectron spectroscopy is suggested as a sensitive means for further analysis of these effects.
科研通智能强力驱动
Strongly Powered by AbleSci AI