材料科学
断裂韧性
极限抗拉强度
钛合金
复合材料
断裂(地质)
合金
脆性
变形(气象学)
冶金
作者
Yakai Xiao,Guian Qian,Jianping Sun,Filippo Berto,José A.F.O. Correia,Youshi Hong
标识
DOI:10.1016/j.tafmec.2023.103931
摘要
Research on low temperature resistance and fracture behavior of additively manufactured (AMed) titanium alloy is lacking. In this study, both tensile and fracture behavior of Ti6Al4V alloy produced by laser powder bed fusion (LPBF) were investigated at four temperatures (293, 223, 173, 123 K). Microscopic observation and finite element analysis were used to study the fracture mechanism. A correlation of fracture toughness and temperature between 123 and 293 K was obtained. As the temperature decreases, the fracture mode of the specimen changes from ductile fracture to a mixed mode of ductile and brittle fracture, the tensile strength increases and the fracture toughness decreases. These differences could be interpreted by the crack tip plastic zone (CTPZ) and microscopic plastic deformation. Compared to the wrought Ti6Al4V alloy, the fracture originations are mainly from LPBF defects, i.e., lack of fusion (LOF) defects and gas pores.
科研通智能强力驱动
Strongly Powered by AbleSci AI