Power amplifiers

RF signals will often need to be transmitted with considerable power if they are to survive propagation with adequate signal level. As a consequence, we will need to consider amplifiers that can operate at large signal levels. Up to this point, we have concentrated on small signal amplifiers for which efficiency and linearity have not been a major problem. These aspects, however, require careful consideration in the case of RF amplifiers operating at large signal levels. Small signal amplifiers are typically of the class A variety and highly linear. Whilst class A amplifiers are sometimes used at high power levels, they do not represent an efficient use of the d.c. energy that is supplied to the amplifier. Class B, AB, C and E amplifiers are far more efficient, but have the disadvantage that they are highly non-linear and hence create considerable harmonics. These harmonics can be troublesome and require specialised techniques, or filtering, for them to be brought down to an acceptable level. The following chapter considers power amplifiers in the class range from A to E. It concentrates on BJT amplifiers, but the same principles can be applied to FET amplifiers.