A New Way to Predict Capacity of Piles in Clay

堆 岩土工程 无量纲量 抗剪强度(土壤) 粘土 结构工程 地质学 承载力 工程类 土壤水分 机械 土壤科学 物理
作者
John A. Focht,Vasant N. Vijayvergiya
出处
期刊:Offshore Technology Conference 被引量:63
标识
DOI:10.4043/1718-ms
摘要

ABSTRACT According to a new concept proposed for correlating results of pile load tests with soil parameters, the total frictional capacity of pipe piles embedded entirely in clay is expressed as Qs = ?(_?m + 2 cm)As, where _?m is the mean effective vertical stress between the ground surface and the pile tip, cm is the mean undrained shear strength along the pile As is the pile surface area, and ? is a dimensionless coefficient. Using this concept, values of ? were determined for 43 previously reported load tests on steel pipe piles in clay and 4 additional tests not previously reported. For these tests including piles 8 to 333 ft long with capacities of 6 to 1760 kips, the frictional capacity coefficient ? was found to have a close correlation with embedded pile length. Application of the new criteria to typical clay profiles indicates lesser capacities for very stiff to hard clays the new criteria will predict capacities greater than the API procedure. Prediction of pile capacity by this new procedure based on effective vertical stress as well as undrained shear strength is shown to have greater reliability than by precious methods based solely on shear strength. INTRODUCTION The static method of predetermining the bearing capacity of piles is based on empirical data gathered from model studies and field load tests and interpreted in accordance with accepted soil mechanics theories. The ultimate pile capacity, Q, at a given penetration is the sum of Qs, the skin frictional capacity, and Qp, the end bearing or point capacity, so that(mathematical equation)(available in full paper) Where dAs and Ap represent, the embedded elemental surface area at any depth and the cross sectional area at the pile tip, respectively; f and q represent the unit skin friction and the unit end bearing, respectively. Various methods have been suggested previously for the prediction of f based on the shear strength of the clay. Mansur (10), Seed(18) and Tomlinson(19) have suggested that the unit skin friction, f, along the pile shaft in soft to firm clays is approximately equal to the undrained shear strength of the clay. From a comprehensive study of comparative behavior of friction piles, Peck (16) concluded that friction piles in stiff clays do not develop the full strength of the clay. Based on large number of pile load tests, Tomlinson(19) suggested that skin friction may be a function of pile material and therefore should be limited by adhesion between pile and soil; the adhesion values suggested were considerably lower than the shear strength of the clay. Woodward (23) reported that skin friction observed during a series of pile load tests was greater than the adhesion values suggested by Tomlinson, though it was less than the shear strength of the clay. In a later paper(20), Tomlinson concluded that the mobilized adhesion is also influenced by the sequence of soil strata into which the pile is driven. McCleland, Focht and Emrich(13) suggested a general predictive criteria giving depth some consideration in addition to shear strength. For stiff over-consolidated clay, the unit skin friction by this procedure is computed as 100 psf or 33 percent of the effective overburden pressure.
最长约 10秒,即可获得该文献文件

科研通智能强力驱动
Strongly Powered by AbleSci AI
科研通是完全免费的文献互助平台,具备全网最快的应助速度,最高的求助完成率。 对每一个文献求助,科研通都将尽心尽力,给求助人一个满意的交代。
实时播报
粗心的烨伟完成签到,获得积分10
2秒前
悦耳的香萱完成签到,获得积分10
3秒前
汉堡包的应助被范yx采纳,获得10
4秒前
JamesPei的应助被范yx采纳,获得10
4秒前
我是老大的应助被范yx采纳,获得10
5秒前
李健的小迷弟的应助被范yx采纳,获得10
5秒前
思源的应助被范yx采纳,获得10
5秒前
科研通AI6.3的应助被范yx采纳,获得10
5秒前
今后的应助被范yx采纳,获得10
5秒前
小二郎的应助被范yx采纳,获得10
6秒前
汉堡包的应助被范yx采纳,获得10
6秒前
科研通AI65的应助被范yx采纳,获得10
6秒前
8秒前
乐观的黎云完成签到 ,获得积分10
8秒前
中微子完成签到 ,获得积分10
9秒前
amiee发布了新的文献求助10
13秒前
磊磊的应助被紫熊采纳,获得10
17秒前
风吹麦浪的应助被amiee采纳,获得10
21秒前
娟娟完成签到 ,获得积分10
23秒前
听书人完成签到,获得积分10
25秒前
happy2016完成签到 ,获得积分10
26秒前
123456777完成签到 ,获得积分0
28秒前
鳄鱼叁叁完成签到 ,获得积分10
28秒前
轻松香菇完成签到 ,获得积分10
28秒前
Jerry完成签到 ,获得积分10
34秒前
忧心的藏鸟完成签到 ,获得积分10
36秒前
小小吴完成签到,获得积分10
36秒前
39秒前
深情安青的应助被Lee0923采纳,获得30
41秒前
道明嗣完成签到 ,获得积分10
42秒前
机智的白卉的应助被Wang采纳,获得10
44秒前
鲜艳的梦菡完成签到 ,获得积分10
44秒前
Rice完成签到,获得积分10
44秒前
花卷发布了新的文献求助10
45秒前
kkk完成签到 ,获得积分10
46秒前
机智的白卉的应助被织梦师采纳,获得10
49秒前
剪刀手完成签到 ,获得积分20
53秒前
xushanfeng完成签到 ,获得积分10
57秒前
上官凯凯完成签到 ,获得积分10
59秒前
smile完成签到 ,获得积分10
59秒前
高分求助中
(应助此贴封号)【重要!!请各用户(尤其是新用户)详细阅读】【科研通的精品贴汇总】 10000
拉伸高分子熔体中缠结行为的模拟和小角中子散射研究 1700
The World Atlas of Wine 9th edition 1000
奈特基础组织学:配套组织病理学(第4版)(Netter's Essential Histology With Correlated Histopathology) 800
八旗制度の研究 600
高分子基功能界面水蒸发材料与应用研究 500
外场增强的水汽发电研究 500
热门求助领域 (近24小时)
化学 材料科学 医学 生物 纳米技术 计算机科学 工程类 有机化学 化学工程 生物化学 物理 复合材料 内科学 催化作用 光电子学 人工智能 细胞生物学 无机化学 物理化学 数学
热门帖子
关注 科研通微信公众号,转发送积分 8185520
求助须知:如何正确求助?哪些是违规求助? 9574253
关于积分的说明 21834609
捐赠科研通 7783129
什么是DOI,文献DOI怎么找? 3434577
关于科研通互助平台的介绍 2558951
邀请新用户注册赠送积分活动 2481357