Numerical and experimental study on effect of induction heating parameters on the coating of Zn layer on mild steel

The objective of the study is to determine the most effective induction heating parameters for melting pure zinc selectively over the mild steel substrate surface. The numerical simulation on effect of induction heating parameters on the mild steel substrate is studied using COMSOL Multiphysics 5.6 software. The optimised effective parameters are used for the experimental analysis for the validation. Variables such as coil configuration, stand-off distance (SOD), coil current and frequency were systematically changed, and optimal settings were chosen on the basis of time temperature contour curve and the heating rate within the material. Results of the numerical analysis portrayed that a pancake coil geometrical configuration, SOD of 2 mm, coil current of 300 A and alternating frequency of 300 kHz were found as the optimum set of parameters for the effective surface repair. An experimental investigation was carried out by depositing a thin layer of zinc on mild steel substrate using the optimized parameters. The surface integrity of the coated specimen was examined through the high-resolution optical microscopy, X-ray diffraction and electron back scattered diffraction (EBSD) techniques. The hardness property of the coated specimen was examined with a Vickers microhardness tester. The microstructure analysis and hardness measurement showed that consistent coating is achieved without affecting the base metal/substrate properties. The experimental results very much coincide with the numerical simulation.