摘要
Over the past two decades, catalytic techniques have shown promises for the direct removal of NO and other NOx from emission gases. In principle, the simple decomposition of NO into N2 and O2, a thermodynamically favorable reaction at low temperature, is desirable. However, the reaction is very slow and sufficiently active catalysts have not been discovered. As a result, CO, methane, propane and other hydrocarbons have been tested as reductants to reduce NO into N2. But these reactions require the catalysts made of noble metals such as Pt, Pd, and Rh, and high cost of facilities, and still suffer from the low removal efficiencies at low temperature. More recently, the selective catalytic reduction (SCR), particularly those using NH3 to selectively reduce NOx under the excessive oxygen condition, have been extensively studied and applied to eliminate NOx from stationary sources such as power plants, and automotive exhausts. Such technique offers the advantages of low cost, high selectivity of NH3 reaction with NO in the presence of oxygen, and the possibility for converting the noxious gas to one or more innocuous substances such as nitrogen gas and water, which are free of disposal problems. However, the reaction mechanism of selective catalytic reduction of nitrogen oxides by NH3 is not well understood yet because reactions are complicated with the different proportions of ammonia, nitric oxide and oxygen at different temperatures in SCR system. The NH3-SCR technique still contains some severe disadvantages such as NH3-slip by unreacted and/or excess NH3 and high operation temperature and thus high cost of facilities. In this study, a novel copper-based catalyst has been synthesized and evaluated for its efficiency on the selective catalytic reduction of nitric oxide (NO) using ammonia (NH3) as a reductant in the temperature range of 50~500 o C. The Brunauer-Emmett-Teller (BET) method, Energy Dispersive X-ray Spectrometry (EDS) and Scanning Electron Microscopy (SEM) have been used to characterize the catalysts developed. The effects of reaction parameters including temperature, space velocity, oxygen concentration, and the ratio of ammonia to nitric oxide on the selective catalytic reduction of NO by NH3 on the synthesized catalyst, as well as the chemical mechanisms and the side reactions involved have been examined. The catalyst shows high activity for NO conversion (90%) with a NH3/NO ratio of about 1 in the presence of O2 (~ 3% v/v) at a temperature of 200 o C. At a temperature of 200 o C or below, only selective (desirable) catalytic reactions occur. At temperatures above 200 o C, ammonia was gradually oxidized to NO and NO2, and thus led to a low NO removal efficiency. The NO conversion also increased with decreasing space velocity between 3600 hr -1 ~7800 hr -1 . The results obtained in this study indicate that the Cu-V/Al2O3 is a very promising catalyst for the elimination of NO using NH3 as a reductant in flue gases.