Experimental investigation on interfacial defect detection for SCCS with conventional and novel contact NDT techniques

Abstract In order to ensure the mechanical performance and structural safety of steel–concrete composite structures (SCCS), advanced nondestructive testing (NDT) technique for bonding status at steel–concrete interfaces needs to be developed. In this study, the feasibility of multichannel analysis of surface waves (MASW)-based interfacial debonding detection is validated using the contact sensors array. Herein, the multichannel sensor arrays are composed of piezoceramic lead zirconate titanate patches and high-frequency acceleration meters, respectively. For comparison, the impact-response (IR) method and impact-transmission (IT) method are performed utilizing a force hammer and high-frequency acceleration meters, and corresponding damage imaging algorithms are developed. The applicability of ultrasonic computed tomography (CT) scanning test, scanning impact echo (IE) method, ultrasonic tomography (UT) technique on interfacial debonding detection is further discussed in depth. Research findings indicate that the developed contact MASW measurement can fully capture the variation of dispersion characteristics of surface waves induced by debonding defects in SCCS. The developed IR and IT methods are suitable for detecting interfacial debondings in different dimensions. Besides, the damage nephogram resolution of IR is higher than that of the IT method. In addition, the practicability of traditional ultrasonic CT scanning tests, scanning IE method, and UT techniques using commercial equipment is investigated. Experimental observations show that classical NDT testing techniques are incapable of effectively identifying the existence of interfacial damage and are unsuitable for NDT tests on SCCS. The research findings in this study clearly exhibit the precision and limitation of various contact NDT techniques and lay a solid foundation for interfacial debonding detection in practical SCCS.