Disinfection by-products control in wastewater effluents treated with ozone and biological activated carbon followed by UV/Chlor(am)ine processes

Sequential utilization of ozone (O3) and biological activated carbon (BAC) followed by UV/chlor(am)ine advanced oxidation process (AOP) has drawn attention in water reuse. However, the formation of disinfection by-products (DBPs) in this process is less evaluated. This study investigated the DBP formation and the relevant toxicity during the O3-BAC-UV/chlor(am)ine treatment of sand-filtered municipal secondary effluent. DBP formation in UV/chlorine and UV/dichloramine (NHCl2) processes were compared, where the impact of key operational parameters (e.g., UV wavelength, pH) on DBP formation were comprehensively evaluated. O3-BAC significantly reduced DBP formation potential (DBPFP) (58.2 %). Compared to UV/chlorine AOP, UV/NHCl2 AOP reduced DBP formation by 29.7 % in short-time treatment, while insignificantly impacting on DBPFP (p > 0.05). UV/NHCl2 AOP also led to lower calculated cytotoxicity (67.7 %) and genotoxicity (55.9 %) of DBPs compared to UV/chlorine AOP. Compared to 254 nm UV light, the utilization of 285 nm UV light decreased the formation of DBPs in wastewater treated with the UV/chlorine AOP and UV/NHCl2 AOP by 31.3 % and 19.2 %, respectively. However, the cytotoxicity and genotoxicity in UV/NHCl2 AOP using 285 nm UV light increased by 83.4 % and 58.5 %, respectively, compared to 254 nm. The concentration of DBPs formed in the UV/NHCl2 AOP at pH 8 was 54.3 % lower than that at pH 7, suggesting a better control of DBPs at alkaline condition. In the presence of bromide, UV/NHCl2 AOP tended to generate more brominated DBPs than UV/chlorine AOP. Overall, UV/NHCl2 AOP resulted in lower concentration and toxicity of DBPs compared to UV/chlorine AOP.