Comparison of different approaches to texturing monocrystalline silicon wafers for solar cell applications

Texturing the surface of crystalline silicon wafers is a very important step in the production of high-efficiency solar cells. Alkaline texturing creates pyramids on the silicon surface, lowering surface reflectivity and improving light trapping in solar cells. This article provides a comparative evaluation of various wet texturing methods using alkaline solutions with or without additives commonly known as surfactants. One method uses sodium hydroxide (NaOH) and isopropyl alcohol (IPA) to create a surface with a height of about 4.5 um by texturing for about 20 minutes, while the other method uses potassium hydroxide (KOH) and other additions known as additives. Texturing was performed using chemicals for only 15 minutes to create a surface shape with a height of approximately 3.5um. Additionally, the two solutions showed reflectance of 8.01% or 12.1% in 400-1100nm, respectively. Both processes used alkaline etching at 80°C for saw damage removal (SDR) before texturing. These processes have also been investigated in terms of removing potential organic contaminants from surfaces. Characterization techniques used throughout the investigation included optical microscopy, surface reflectance measurements, scanning electron microscopy (SEM), and electron dispersive spectroscopy (EDS). The purpose of this study is to confirm through experiments which texturing techniques are more suitable for mass production and to develop time- and cost-effective texturing techniques for industrial production of high-throughput, high-efficiency solar cells.