可靠性(半导体)
压力传感器
压力(语言学)
材料科学
微电子机械系统
图层(电子)
炸薯条
胶粘剂
电子包装
结构工程
振动
有限元法
计算机模拟
机械工程
影响
灵敏度(控制系统)
材料性能
倒装芯片
汽车工程
电子工程
变形(气象学)
复合材料
作者
Nan Ji,Anqing Fu,Chunyong Huo,Hanyang Xu
标识
DOI:10.1088/1742-6596/3184/1/012016
摘要
Abstract MEMS pressure sensors face higher technical requirements in high-pressure environments such as oil, natural gas, and aerospace. Complex mechanical environments, such as impact and vibration will damage the packaging structure of sensors and reduce its reliability. This paper analyzes the reliability of the oil-filled high-pressure MEMS sensor package structure under the impact load environment of oil well by numerical simulation method. The simulation analysis covers the influence of different adhesive layer thickness and bubble defects on the sensor structure under three-axis impact load. The results show that the maximum stress of the sensor package structure and the sensor chip under the action of the three-axis impact is less than 2.5 MPa and 0.14 MPa respectively, which is far lower than the yield strength and allowable stress of each material of the sensor. In addition, when the thickness of the adhesive layer is between 100 µm and 200 µm, increasing the thickness of the adhesive can reduce the stress on the sensor chip. Meanwhile, the bubbles in the adhesive layer can cause stress concentration. However, the stress concentration only appears in the local area of the bubble, and the influence on the chip stress under the three-axis impact load is minimal. This paper provides a theoretical basis for packaging design and optimization of MEMS pressure sensors under three-axis impact.
科研通智能强力驱动
Strongly Powered by AbleSci AI