材料科学
压阻效应
膜
导电体
复合材料
热的
碳纳米纤维
热导率
调制(音乐)
信号(编程语言)
碳化
纳米技术
光电子学
响应时间
碳纳米管
碳纤维
热传导
纳米纤维
压力传感器
接触面积
探测器
电导率
作者
Die Liu,Zhengyu Ding,Herui Yan,Yuling Nie,Jiaqiang Li,Jun Zhang,Binjie Xin,Zhuoming Chen
标识
DOI:10.1021/acsami.6c12575
摘要
Flexible piezoresistive sensors for protective textiles should maintain pressure-responsive conductivity after thermal exposure, whereas many polymer-based sensing layers soften, degrade, or lose signal output under heat. Herein, we report a self-supporting PAN/PI-derived carbon nanofibrous membrane with MXene-assisted contact modulation for heat-resistant piezoresistive sensing and temperature-triggered warning. Electrospun PAN/PAA membranes were stabilized and carbonized to construct a thermally durable conductive fibrous framework, in which PAN serves as the principal carbon-forming precursor and the PAA-derived PI intermediate assists structural retention during thermal conversion. Surface-deposited Ti3C2Tx MXene nanosheets further introduce conductive junctions and pressure-responsive contact interfaces. The optimized PPNF-MX3 sensor exhibits a broad pressure range of 0.05-250 kPa, a low-pressure sensitivity of 8.16 kPa-1, and response/recovery times of 520/572 ms. It retains 97.51% of its electromechanical response after 10,000 bending-release cycles at room temperature and 83.16% after 1200 cycles following thermal exposure at 350 °C for 660 s. The carbonized membrane exhibits thermal-shielding behavior and flame-induced structural retention, while the integrated system enables repeatable temperature-triggered warning at 495 °C. These results demonstrate the potential of PPNF-MX3 as a multifunctional sensing and thermal-warning platform for intelligent protective textiles exposed to demanding thermal environments.
科研通智能强力驱动
Strongly Powered by AbleSci AI