TAGUCHI GREY RELATIONAL MULTI-RESPONSE EXPERIMENTAL OPTIMIZATION ON MODIFICATION OF Al-6061 SURFACE USING Si–Cu GREEN COMPACT TOOL IN EDM

This paper presents the surface modification of aluminium-6061 by electric discharge machining (EDM). Si–Cu powder metallurgical green compact tool is used to deposit its material on to the work surface under reverse polarity of EDM. Compact load, current and pulse on-time are selected control parameters. Material deposition rate (MDR), tool wear rate (TWR) and surface roughness ([Formula: see text] are considered as process outputs. Scanning electron microscopic (SEM) analysis and energy dispersive X-ray (EDX) analysis show the presence of tool materials in the deposit of work surface. Olympus optical micrograph shows an average thickness of the deposited layer to be 18.73[Formula: see text][Formula: see text]m. The hardness of the deposited layer is found to be 268[Formula: see text]HV. Analysis of variance (ANOVA) shows the compact load to be the most effective parameter on surface modification followed by pulse on-time and current, respectively.