材料科学
莫来石
陶瓷
3D打印
制作
断裂韧性
复合材料
抗弯强度
数字光处理
脆性
韧性
微观结构
增韧
近净形状
冶金
原位
3d打印
3d打印机
氧化铝陶瓷
墨水池
陶瓷基复合材料
锡膏
作者
Ying Qiao,Xinxin Cao,Wei Ning,Yongqi Liang,Guifang Han
标识
DOI:10.1002/adem.202502545
摘要
Alumina‐based ceramics demonstrate remarkable hardness and wear resistance; however, their intrinsic high brittleness and low fracture toughness pose significant challenges in the fabrication of complex components using conventional processing techniques. The emergence of additive manufacturing technology has enabled the fabrication of complex‐structured alumina ceramics. In this study, nano‐silica (SiO 2 ) was incorporated into zirconia‐toughened alumina (ZTA) ceramic powders for digital light processing (DLP) 3D printing. During subsequent debinding and sintering, the SiO 2 reacted in situ with alumina to form mullite particles, which contributed to microstructural refinement and toughening. Optimal properties‐Vickers hardness (16.2 GPa), flexural strength (463.8 MPa), and fracture toughness (4.34 MPa·m 1/2 )‐were achieved at 3 wt% SiO 2 . The mechanical performance of the printed ceramics was significantly enhanced, demonstrating a novel strategy for producing high‐strength alumina‐based ceramics via DLP 3D printing.
科研通智能强力驱动
Strongly Powered by AbleSci AI