Multi-Shot Icing Simulation for Airfoils by JAXA FaSTAR-ICE
作者
Kei Shimura,Ide Yuki
出处
期刊: [American Institute of Aeronautics and Astronautics] 日期:2024-07-27
标识
DOI:10.2514/6.2024-3609
摘要
In this study, multi-shot icing simulations for two- and three-dimensional airfoils were performed to validate a newly developed in-house code in JAXA, FaSTAR-ICE. Icings on NACA 23012, RG-15, and hybrid CRM65 midspan model were calculated and compared to CFD and experimental results in Ice Prediction Workshops 2021 and 2023. The calculation for NACA23012 wing reproduced successfully icing processes, namely pressure distributions, droplet collection efficiency, and icing characteristics of glaze and rime. On the other hand, for RG-15 wing whose flow conditions correspond to low Reynolds number cases, simulated ice shapes are lacking in some characteristics: the horn extending diagonally upward due to the short runback distance near the leading edge. Only the horns extending in the opposite direction of the flow were observed. This might be due to the flow separation at the top of the horns, occurred during the first few cycles in the present multi-shot. The separation could prevent the water film from flowing over the top due to reverse shear stress. For the calculations of CRM65 3D airfoil, the present simulation In CRM65 midspan model calculation, the current simulation can be calculated stably in multi-shot, however mixed ice characteristics could not reproduce. Therefore, it is suggested that in multi-shot simulation ice shapes at the first few cycles has significant effects on the final shape, like the angle of horn extension. In addition, more accurate method to predict water freezing is needed to simulate the mixed ice for the prediction of ice characteristics.